Pertronix Dougs Headers D923 Manual do Utilizador descarregar pdf (Página 2)

Page 2

Part No. 0110-003053 rev. 1 11-19-13 DSL

ASSEMBLY

1. Install Doug’s Header Part No. D6681 per instructions.

2. Install the X-Pipe assembly to the headers.

3. Install hangers in stock rubber mounts and tighten clamps.

4. Connect to exhaust system and tighten all bolts.

5. Tighten all the bolts.

6. Reinstall the O

sensors.

7. Connect the negative battery cable.

START THE ENGINE

Start the engine and allow it to warm up to operating temperature. Check for any unusual

noises or exhaust leaks. If every thing is OK, stop the engine and tighten all bolts while

the engine is still warm.

NOTE: Check the bolts periodically to make sure they have not loosened. Re-tighten

after the first 500 miles and then again at 1000 miles.

IMPORTANT CHECK LIST

Be sure that all brake lines and fuel lines are clear of headers and/or connector

pipes.

All spark plug wires, battery cables, or other electrical components should be clear

of headers and/or connector pipes.

Double-check the tightness of all bolts including brackets and accessories.

PARTS LIST

Qty Description

1 X-Pipe

1 Connector Pipe

2 3” T-bolt clamps

1 2-1/2” T-bolt clamp

4 7/16” lock-washers

4 Nut, hex, 7/16”-14

4 Screw, cap, hex head, 7/16”-14 x 2-1/2”

1 2

Sem comentários

Pertronix Dougs Headers D923 Manual do Utilizador Página 2